Installation Procedures
1. Hazard Assessment
Survey set up locations for the purpose of controlling and eliminating hazards which may compromise the safe use of the Safety Rail System
Ensure geographic health and safety regulations are in compliance prior to erection
2. Tape measure
Measure width of the parapet to pre-set width allowing for setting Adjusting Clamp away from leading edge
Measure and mark locations at 10 intervals for straight post locations and set straight post to accommodate a height between 18 for mid cable and 36 for top cable.
3. Winch
Follow attaching cable to winch drum instructions
Cut 6 feet of cable from supplied cable
Install one end to hand winch drum
Loop one end through hook
Mount winch to end post (use two 3/8 bolts)
Refer to Diagram A and B
4. Adjustable Clamp
Adjust clamp to fit parapet install quick pin
Tighten T bolt until in a snug tight to parapet at predetermined locations (do not over tighten)
5. Corner Post
Ensure adequate substrate strength
Fasten to inside and outside corners as per Professional Engineering specifications
Refer to engineer design specification for fasteners
Install quick pin
Refer to Diagram C
6. Straight Post
Install post with cable keepers to inside of parapet
Mount every 10 at predetermined locations
Install quick pins
Refer to Diagram C
7. Combo End Post
Mount winch on one end post
Start with end post end with end post at Safety Rail System termination point
Install quick pins
Ensure substrate of adequate design and good construction
Fasten as per Professional Engineering specifications
Refer to Diagram A and C
8. Combo Break Post
Determine area for hoisting and garbage removal
Slip break post cable tie downs over parapet clamp
Install quick pins
Fasten as per Professional Engineering specifications
Refer to Diagram C
9. Threading Cable through Rail
Place cable spool beside hand winch
Loop end of cable (Diagram B)
Thread cable through mid rail and top rail (Diagram A, C, and D) by hand, pull all loose cable back to winch
Hook loop and winch in slack cable
Ensure lock mechanism is set on winch
10. Inspection
Complete visual inspection upon erection
Double check T bolt on Adjustable Clamp until in a snug tight to parapet at predetermined locations
Ensure Safe Work Practices and Job Procedures developed for the use of the Safety Rail System identifies that workers do not lean on cable or steel components of the system when working in vicinity
.
. |